Flash Sale 😀 Everbuild Black Jack Self Adhesive Flashing Tape 10m 300mm FLAS300 😍

Everbuild Black Jack Lead Grey Colour Flashing Tape 10m x 300mm

MPN: FLAS300

Barcode: 5029347099053

Everbuild Flashing Tape 300mm 12 inch Wide Aluminium foil and bitumen rubber self adhesive flashing tape in Lead Grey Colour

The adhesive forms a strong waterproof seal by the simply pressing the tape into place by hand or roller.

Areas Flashing Tape Can Be Use and Benefit:

Replaces need for expensive lead flashing

Self-adhesive requires no separate glue

General repair to existing flashing

Flashing bituminous felt and similar types of roofs

Flashing parapet walls

Sealing roof glazing

Replacing lost lead flashing

Repairs to cracks in concrete

Repairs to lead gutters

Sealing capping bolts in roof sheets

Sealing roof ridges

Flashing between timber brickwork or blockwork cavities

Flashing of skylights

Important Product Notes:

Prime porous surfaces with Everbuild flashing primer

Do not apply to damp surfaces

In cold weather adhesion may be reduced

Bring up to temperature or heat bitumen adhesive layer with a hot air gun to improve adhesion & pliability

Awkward areas and tops of existing lead flashing can be pointed using Everbuild Lead mate

Preparation of Surfaces and Application:

Surfaces must be dry,

Sound free from oil, grease and dust

Remove all loose material by scraper or wire brush

Porous surfaces, such as concrete or brick, should be primed using Everbuild flashing primer

Cut to the required length peel beck approximately 5cm of release carrier and place the tape into position Continue removing the release carrier whilst firmly placing the tape and avoid unnecessary creasing, ensure intimate contact and ensure no air is trapped, using a small roller ensure that all edges and overlaps are sealed properly, overlaps should be at least 25mm.

Everbuild Official Data Sheets:

Everbuild 300mm Flashing Tape Instructions Technical Data Sheet

Everbuild Flashing Tape Product Page

All Flashing Tape Products