Promo ⌛ Sika Multiseal Sealing Flashing Tape 300mm X 10m SKMULTI300 🔔

Product Option: 300mm x 10m

MPN: SKMULTI300

Barcode: 5055492700315

Sika Multiseal Sealing Flashing Tape a 300mm Wide Strong self adhesive flashing tape with a strong self-adhesive bituminous adhesive sealing tape for the sealing of cracks and joints in many common domestic and commercial situations.

Made from aluminium foil reinforced by a polyester film and coated with a cold-adhesive bituminous compound, simply press the tape into place by hand or seam type roller.

Multi Seal Benefits:

Replaces need for expensive lead flashing.

Self-adhesive requires no separate glue.

Very easy to apply

Very economical

Good adhesion to many substrates

Weather-proof

UV-resistant

Can be over-painted

Can be applied at low temperatures

Areas of Use:

General repair to existing flashing.

Flashing bituminous felt and similar types of roofs.

Flashing parapet walls.

Sealing roof glazing.

Replacing lost lead flashing.

Repairs to cracks in concrete.

Repairs to lead gutters.

Sealing capping bolts in roof sheets.

Sealing roof ridges.

Flashing between timber brickwork or blockwork cavities.

Flashing of skylights

Notes:

Prime very porous surfaces with Everbuild flashing primer.

Do not apply to damp surfaces.

In cold weather adhesion may be reduced.

Bring up to temperature or heat bitumen adhesive layer gently with a hot air gun

to improve adhesion & pliability.

Awkward areas and tops of existing lead flashing can be pointed using Everbuild Lead mate larger flat areas can be coated with Evercryl Fibre reinforced coating.

Preparation:

Surfaces must be dry, sound free from oil, grease and dust, remove all loose material by scraper or wire brush.

Porous surfaces, such as concrete or brick, should be primed using Everbuild flashing tape primer.

Video Demonstration of the Sika Multiseal Sealing Tape.

Applying:

Cut to the required length.

Peel beck approximately 5cm of release carrier and place the tape into position.

Continue removing the release carrier whilst firmly placing the tape

Avoid unnecessary creasing.

Ensure intimate contact and ensure no air is trapped.

Using a small roller ensure that all edges and overlaps are sealed properly.

Overlaps should be at least 25mm.

SKMULTI300 Official Information:

Manufacturer Sika Flashing Tape Product Page